3/3/2023 0 Comments Wifi pringles can![]() ![]() ![]() Then when I did my actual testing, I filtered my results to only display one AP's signal. Since I work where there are many APs, this was my main code. First is to roll through all the 2.4gHz networks on the screen. There's three different versions of the code. ![]() The code I wrote is an adaptation of the wifi scan. I felt that the way I did it encompassed the “hacker" mentality of doing what's needed to get the job done. Here I did a loop of a zip tie through the end of the can, then held it in place with a large paper clip. I tucked the battery into the left side, allowing just enough wire length to connect it. With that in place, I connected the antenna to the LinkIt, and the placed the LinkIt against the can, and put one zip tie on snugly to keep it from going anywhere. Last thing I needed to do was to break my wifi card. I then attached the antenna towards one of the in-can portion of the zip tie, making sure I had enough of the tail to comfortably attach to the LinkIt without strain. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |